TM-9-2320-366-34-4 MTV Direct Maintenance Manual M1083 Series - Volume 4 Download
Page 345 of 796
TM 9-2320-366-34-4 b. Cleaning/Inspection. WARNING • Dry Cleaning Solvent (P-D-680) is TOXIC and flammable. Wear protective goggles and gloves; use only in well ventilated area; avoid contact with skin, eyes, and clothes, and do not breathe vapors. Keep away from heat or flame. Never smoke when using solvent; the flashpoint for Type I Dry Cleaning Solvent is 100°F (38°C) and for Type II is 130°F (50°C). Failure to comply may result in serious injury or death to personnel. • If personnel become dizzy while using cleaning solvent, immediately get fresh air and medical help. If solvent contacts skin or clothes, flush with cold water. If solvent contacts eyes, immediately flush eyes with water and get immediate medical attention. Failure to comply may result in serious injury or death to personnel. (1) Clean sealant residue from threaded holes with dry cleaning solvent. CAUTION Clean machined parts separately to avoid damage from parts bumping together. Failure to comply may result in damage to equipment. (2) Clean all metal parts in dry cleaning solvent. WARNING Compressed air for cleaning purposes will not exceed 30 psi (207 kPa). Use only with effective chip guarding and personal protective equipment (goggles/shield, gloves, etc.). Failure to comply may result in injury to personnel or damage to equipment. (3) Dry all metal parts except bearing cones (1) with compressed air. Allow bearing cones to air dry. NOTE Replace any part that fails visual inspection. (4) Inspect input yoke (2) for visible cracks, wear, or damage. (5) Inspect four bearing cones (1) and bearing cups (3) for visible cracks, wear, or damage. (6) Inspect bearing cage (4) for visible cracks, wear, or damage. Change 1 23-7