TM-9-2320-366-34-4 MTV Direct Maintenance Manual M1083 Series - Volume 4 Download
Page 334 of 796
TM 9-2320-366-34-4 22-4. TRANSFER CASE HOUSING REPAIR (CONT) (15) Rotate transfer case housing (2) until open end is facing up. CAUTION Ensure center idler, upper drive, and lower driven gears with bearing cones are seated in transfer case housing. Failure to comply may result in damage to equipment. NOTE Install idler gear with threaded hole toward transfer case housing. (16) Install center idler gear (17) in transfer case housing (2). (17) Install upper drive gear (19) in transfer case housing (2). (18) Install lower driven gear (21) in transfer case housing (2). WARNING Transfer case cover weighs approximately 75 lbs (34 kgs). The aid of an assistant is required to safely lift it. Failure to comply may result in injury to personnel or damage to equipment. NOTE Step (19) requires the aid of an assistant. (19) Install gasket (22) and transfer case cover (9) on transfer case housing (2). (20) Position 15 bolts (23) in transfer case housing (2). (21) Tighten 15 bolts (23) to 44-55 lb-ft (60-75 N·m). (22) Rotate transfer case cover (9) until transfer case housing (2) is facing up. 22-18