TM-9-2320-366-34-4 MTV Direct Maintenance Manual M1083 Series - Volume 4 Download
Page 308 of 796
TM 9-2320-366-34-4 21-14. C6 CLUTCH HOUSING ASSEMBLY REPAIR This task covers: a. Disassembly b. Cleaning/Inspection c. Assembly d. Follow-On Maintenance INITIAL SETUP Equipment Conditions Transfer case module disassembled (para 22-3). Tools and Special Tools Tool Kit, Genl Mech (Item 78, Appendix B) Caliper, Vernier (Item 11, Appendix B) Goggles, Industrial (Item 28, Appendix B) Inserter, Bearing and Bushing (TM 9-2320-366-20) Handle, Drive (TM 9-2320-366-20) Inserter and Remover, Spring (TM 9-2320-366-20) Press, Arbor, Hand Operated (Item 48, Appendix B) Tools and Special Tools (Cont) Puller Kit, Mechanical (Item 50, Appendix B) Pliers, Retaining Ring (Item 44, Appendix B) Gloves, Rubber (Item 26, Appendix B) Materials/Parts Oil, Engine Lubricating (Item 46, Appendix C) Rag, Wiping (Item 60, Appendix C) Solvent, Dry Cleaning (Item 83, Appendix C) Seal Ring (Item 406, Appendix F) Seal Ring (Item 407, Appendix F) a. Disassembly. WARNING Use care when removing retaining rings. Retaining rings are under tension and can act as projectiles when released. Failure to comply may result in injury to personnel. (1) Remove retaining ring (1) and C6 backing plate (2) from clutch housing (3). (2) Remove C6 drive hub (4) from clutch housing (3). (3) Remove five C6 friction plates (5) and C6 reaction plates (6) from C6 drive hub (4). CAUTION If transmission is prior to S/N 6510072173, C6 thrust bearing must be replaced. Failure to comply may result in damage to equipment. (4) Remove thrust bearing (7) from clutch housing (3). 21-66