TM-9-2320-366-34-4 MTV Direct Maintenance Manual M1083 Series - Volume 4 Download
Page 286 of 796
TM 9-2320-366-34-4 21-8. MAIN SHAFT MODULE REPAIR (CONT) b. Cleaning/Inspection. (1) Wipe clean all metal parts. NOTE Replace any part that fails visual inspection or size measurement requirements. (2) Inspect main shaft (1) for cracks, nicks, burrs, pitting, and damaged teeth. (3) Measure diameter of main shaft pilot (A), minimum diameter 0.787 in. (1.998 cm). (4) Measure diameter of main shaft pilot (B), minimum diameter 1.387 in. (3.522 cm). (5) Measure outside diameter of main shaft journal area (C) with P2 planetary bushing, minimum outside diameter 1.692 in. (4.297 cm). (6) Inspect thrust bearing (2) for nicks, burrs, cracks, and evidence of excessive wear. (7) Inspect gear (3) for nicks, burrs, cracks, damaged or missing teeth, and corrosion. (8) Inspect spacer (4) for nicks, cracks, burrs, and evidence of excessive wear. (9) Inspect gear (5) for nicks, burrs, cracks, damaged or missing teeth, and corrosion. (10) Inspect thrust bearing (6) for nicks, burrs, cracks, and evidence of excessive wear. 21-44