TM-9-2320-366-34-4 MTV Direct Maintenance Manual M1083 Series - Volume 4 Download
Page 241 of 796
TM 9-2320-366-34-4 b. Installation. (1) Position stub shaft (1) on cylinder block (2) with three bolts (3). (2) Tighten three bolts (3) to 33-47 lb-ft (45-65 N·m). CAUTION Ensure timing marks are aligned as noted during removal. Failure to comply may result in damage to equipment. (3) Install bearing sleeve (4) and idler gear (5) with timing mark outward. WARNING Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors, and are harmful to skin and clothing. Keep away from open fire and use in a well ventilated area. If adhesive, solvent, or sealing compound gets on skin or clothing, wash immediately with soap and water. Failure to comply may result in injury to personnel. (4) Place a bead of sealant on front gear housing (6) seating surface (shaded area). 20-59