TM-9-2320-366-34-4 MTV Direct Maintenance Manual M1083 Series - Volume 4 Download
Page 229 of 796
TM 9-2320-366-34-4 CAUTION Do not turn crankshaft while bearing gage is on connecting rod bearing. Failure to comply will result in inaccurate clearance reading and possible damage to equipment. (29) Remove two connecting rod cap nuts (14) and connecting rod (3) from rod cap (5). (30) Remove rod cap (5) from connecting rod journal (13). (31) Measure greatest width (A) of bearing gage in connecting rod bearing half (12) against chart contained in gage package. Maximum clearance is 0.0061 in. (0.015 cm). Record clearance reading. (32) Clean bearing gage from connecting rod half (12) and connecting rod journal (13). (33) Perform steps (19) through (32) for remaining five connecting rods and rod caps. d. Assembly. NOTE Steps (1) through (9) require the aid of an assistant. (1) Install piston rod bearing (1) in connecting rod (2). (2) Install piston crown (3) on piston skirt (4). (3) Install piston crown (3) on connecting rod (2) with piston pin (5). WARNING Use care when installing retaining rings. Retaining rings are under tension and can act as projectiles when released. Failure to comply may result in injury to personnel. (4) Install two retaining rings (6) on piston pin (5). 20-47