TM-9-2320-366-34-4 MTV Direct Maintenance Manual M1083 Series - Volume 4 Download
Page 228 of 796
TM 9-2320-366-34-4 20-6. PISTON AND CONNECTING ROD ASSEMBLY REPLACEMENT/REPAIR (CONT) WARNING Dry Cleaning Solvent (P-D-680) is TOXIC and flammable. Wear protective goggles and gloves; use only in well ventilated area; avoid contact with skin, eyes, and clothes, and do not breathe vapors. Keep away from heat or flame. Never smoke when using solvent; the flashpoint for Type I Dry Cleaning Solvent is 100°F (38°C) and for Type II is 130°F (50°C). Failure to comply may result in serious injury or death to personnel. If personnel become dizzy while using dry cleaning solvent, immediately get fresh air and medical help. If dry cleaning solvent contacts skin or clothes, flush with cold water. If dry cleaning solvent contacts eyes, immediately flush eyes with water and get immediate medical attention. Failure to comply may result in injury to personnel. (19) Clean and dry two connecting rod bearing halves (12) and crankshaft connecting rod journal (13). (20) Install connecting rod bearing half (12) in rod cap (5). CAUTION Do not allow any bearing gage material to overhang edge of connecting rod bearing half. Failure to comply may result in inaccurate bearing clearance reading. (21) Place bearing gage at crown of connecting rod bearing half (12). (22) Install connecting rod bearing half (12) in connecting rod (3). (23) Position connecting rod (3) in cylinder bore (10) against connecting rod journal (13). (24) Position rod cap (5) on connecting rod (3). (25) Position two connecting rod cap nuts (14) on two connecting rod bolts (15). (26) Tighten two connecting rod cap nuts (14) to 35-45 lb-ft (47-61 N·m). (27) Match mark rod cap (5) and connecting rod cap nut (14). (28) Tighten two connecting rod cap nuts (14) an additional 1/6 turn. 20-46