TM-9-2320-366-34-4 MTV Direct Maintenance Manual M1083 Series - Volume 4 Download
Page 226 of 796
TM 9-2320-366-34-4 20-6. PISTON AND CONNECTING ROD ASSEMBLY REPLACEMENT/REPAIR (CONT) NOTE Replace any part that fails visual inspection or size measurement requirements. (3) Inspect six piston crowns (1) for cracks, wear, and corrosion. (4) Inspect six piston skirts (2) for cracks, wear, and corrosion. (5) Inspect six connecting rods (3) for cracks, wear and corrosion. (6) Measure inside diameter of six piston pin bearings (6). Minimum inside diameter is 1.575 in. (4.002 cm). (7) Inspect six rod caps (5) for cracks, wear and corrosion. (8) Inspect six No. 1 piston rings (7), No. 2 piston rings (8), and oil control rings (9) for cracks and corrosion. (9) Inspect six piston pins (4) for damage, wear, and corrosion. (10) Measure diameter of six piston pins (4). Minimum diameter is 1.574 in. (3.999 cm). NOTE If any cylinder bore exceeds maximum allowable diameter, replace cylinder block. (11) Measure inside diameter of six cylinder bores (10). Maximum allowable bore diameter is 4.135 in. (10.505 cm). 20-44