TM-9-2320-366-34-4 MTV Direct Maintenance Manual M1083 Series - Volume 4 Download
Page 201 of 796
TM 9-2320-366-34-4 (5) Apply sealing compound to injector sleeve bore (1) in cylinder head (2) and outside of injector sleeve (3) at locations (A and B). (6) Install injector sleeve (3) in injector sleeve bore (1) in cylinder head (2). Wipe away any excess sealing compound that is either in or above injector sleeve. (7) Apply grease to lubricate swage assembly (4) and upper inside injector sleeve bore (1). (8) Install swage assembly (4) in injector sleeve (3). Push injector sleeve all the way to the bottom of injector sleeve bore (1) in cylinder head (2). NOTE Use large bushing (identified by an "L" or by a coarse knurl) if it will slip into bore with hand force. If large bushing can not be installed as stated, select smaller bushing (identified by an "S" or a fine knurl). (9) Install guide bushing (5) over swage assembly (4) and into injector sleeve bore (1). (10) Position driver (6) over swage assembly (4). 20-19