TM-9-2320-366-34-4 MTV Direct Maintenance Manual M1083 Series - Volume 4 Download
Page 184 of 796
TM 9-2320-366-34-4 Section II. MAINTENANCE PROCEDURES 20-2. ENGINE TO MAINTENANCE STAND MOUNTING This task covers: a. Mounting b. Demounting c. Follow-On Maintenance INITIAL SETUP Equipment Conditions Engine assembly removed (para 3-3). Starter removed (TM 9-2320-366-20-3). Throttle position sensor cable assembly removed (TM 9-2320-366-20-3). Fuel/water separator removed (TM 9-2320-366- 20-3). Fuel filter base removed (TM 9-2320-366-20-3). Air compressor removed (para 11-2). Engine bracket removed (para 3-5). Tools and Special Tools Tool Kit, Genl Mech (Item 78, Appendix B) Wrench, Torque, 0-175 lb-ft (Item 92, Appendix B) Engine Stand Bracket (Item 9, Appendix D) Stand, Maintenance, Engine (TM 9-2320-366-20) Materials/Parts Packing, Preformed (Item 240, Appendix F) Gasket (Item 41, Appendix F) Packing, Preformed (Item 253, Appendix F) Personnel Required (2) a. Mounting. (1) Remove bolt (1) and washer (2) from fuel tube clip (3). (2) Disconnect fuel tube (4) from 90-degree fitting (5). (3) Remove preformed packing (6) from 90-degree fitting (5). Discard preformed packing. 20-2 Change 1