TM-9-2320-366-34-4 MTV Direct Maintenance Manual M1083 Series - Volume 4 Download
Page 165 of 796
TM 9-2320-366-34-4 (5) Install top platform (8) on cab floor (9) with four washers (10) and screws (11). CAUTION Drill bit stop must be used to limit the depth of drill bit travel. Failure to comply may result in damage to engine components. (6) Drill two 10 mm holes (12) in cab floor (9). (7) Remove four screws (11), washers (10), and top platform (8) from cab floor (9). NOTE Remove all rubber material around holes to ensure metal to metal contact between clinch nuts and cab floor. (8) Cut rubber material from around two holes (12) in floor mat (13) to approximately 3/4 inch. (9) Install two clinch nuts (14) in holes (12). 19-3