TM-9-2320-366-34-4 MTV Direct Maintenance Manual M1083 Series - Volume 4 Download
Page 148 of 796
TM 9-2320-366-34-4 18-94 Change 2 18-7. DIGITIZATION KIT INITIAL INSTALLATION (CONT) (108) Position washers (126) between bottom rear wall brace (91) and rivnuts as required. (109) Apply sealant to threads of two screws (127). (110) Position two washers (128) and screws (127) in bottom rear wall brace (91). (111) Tighten two screws (127) to 70-80 lb-in (8-9 N•m). (112) Position washers (129) between outer side support (87) and rivnuts (6) as required. (113) Apply sealant to threads of three screws (130). (114) Position three washers (131) and screws (130) in outer side support (87). (115) Tighten three screws (130) to 70-80 lb-in (8-9 N•m). (116) Tighten three self-locking nuts (90) to 110-120 lb-in (12-14 N•m). CAUTION WARNING CAUTION Add spacers behind supports on vehicle side panel. Failure to comply may result in damage to equipment. Add spacers behind supports on vehicles equipped with rear panels. Failure to comply may result in damage to equipment. Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors, and are harmful to skin and clothing. Keep away from open fire and use in a well-ventilated area. If adhesive, solvent, or sealing compound gets on skin or clothing, wash immediately with soap and water. Failure to comply may result in injury to personnel.