TM-9-2320-366-34-4 MTV Direct Maintenance Manual M1083 Series - Volume 4 Download
Page 142 of 796
TM 9-2320-366-34-4 18-88 Change 2 18-7. DIGITIZATION KIT INITIAL INSTALLATION (CONT) c. Radio Rack Assembly. (65) Place four support legs (73) in alignment, (66) Count and mark holes in support legs (73) used to mount shelves. Refer to Table 18-1 for locations. (67) Remove paint from support legs (73) at shelf hole locations and top-bottom hole locations. Table 18-1 Support Leg Hole Locations Shelf Hole Location FBCB2 Shelf 6 EPLRS Shelf 17 Power Distribution Shelf 26 Lower Head Rest Support 33 Singars Shelf 36 CAUTION If radio rack is assembled outside of cab, do not install top and bottom support plates until rack is in cab. Failure to comply may result in damage to equipment. NOTE All holes are the same. No. 6 hole shown.