TM-9-2320-366-34-4 MTV Direct Maintenance Manual M1083 Series - Volume 4 Download
Page 133 of 796
TM 9-2320-366-34-4 Change 2 18-79 (4) Enlarge holes at location (4) to 17/32” (13 mm). (5) Enlarge two holes in plastic cab liner (5) at location (4) to 1/2” (13 mm). (6) Apply primer and paint to rear cab wall (2) holes at locations (4). (7) Apply primer and paint to two rivnuts (6). (8) Install rivnuts (6) in rear cab wall (2) holes at location (4). (9) Position RH roof template (7) on cab roof (8) with two clamps. (10) Drill six 3/16” (5 mm) pilot holes at locations (9). (11) Remove two clamps and RH roof template (7) from cab roof (8). CAUTION Enlarge holes only in plastic wall covering. Pull plastic away from rear cab wall if necessary. Failure to comply may result in damage to equipment. NOTE Use primer and paint as indicated in TM Paint TB43-0242.