TM-9-2320-366-34-4 MTV Direct Maintenance Manual M1083 Series - Volume 4 Download
Page 113 of 796
TM 9-2320-366-34-4 (37) Remove 45-degree grease fitting (56) from support (8). (38) Install grease fitting (57) in support (8). NOTE • Use bolts P/N 12414307-142 and self-locking nuts P/N 12414308-025 on step (39). • Support will be installed with fitting facing down. (39) Position support (8) on pintle hook extension (39) with four bolts (7) and self-locking nuts (6). (40) Position pintle hook extension (39) in vise. (41) Tighten four self-locking nuts (6) to 196-240 lb-ft (265- 325 N·m). (42) Position pintle hook (4) in pintle hook extension (39) with washer (3) and nut (2). CAUTION Clearance between washer and support must be 0.003-0.017 in. (0.076-0.432 mm). Failure to comply may result in damage to equipment. (43) Adjust nut (2) until clearance is 0.003-0.017 in. (0.076- 0.432 mm) with alignment holes lined up between nut (2) and pintle hook (4). (44) Install cotter pin (1) in nut (2). Change 1 18-59