TM-9-2320-366-34-3 MTV Direct Maintenance Manual M1083 Series - Volume 3 Download
Page 944 of 1178
TM 9-2320-366-34-3 D-5. CAB SUPPORT TOOL (CONT) Figure D-14. Cab Support Tool Assembly m. Position and clamp cab support tool strut (1) to cab support tool cab rest (2) as shown by dimensions in Figure D-14. Cab Support Tool Assembly, before insulgrip (4) is applied. n. Weld cab support tool strut (1) to cab support tool cab rest (2). o. Apply Insulgrip (4) to cab support tool cab rest (2) as described on material container. D-6. DUMP BED WOODEN BRACE FABRICATION Cut the wooden braces from bulk wood stock according to the information in the table. Finish as described in the following steps. Item Description Size or Dimension Material Description Qty Braces 4 X 4 X 48 in. (10.1 X 10.1 X 121.9 cm) 4 X 4 in. Lumber (MIL-STD-731) 2 a. All dimensions are in inches (centimeters). b. Cut 2 of item 1 from MIL-STD 736 Group IV untreated bulk wood stock as indicated in table. c. Sand and remove sharp edges. D-20 D-20