TM-9-2320-366-34-3 MTV Direct Maintenance Manual M1083 Series - Volume 3 Download
Page 844 of 1178
TM 9-2320-366-34-3 16-93. POWER TAKE-OFF (PTO) REPLACEMENT/REPAIR (CONT) NOTE Perform steps (2) through (5) on PTO Assembly (P/N 276XMF-JX-D5XK). (2) Install two bearings (3) in input gear (4). (3) Install two thrust washers (5) and input gear (4) in housing (2). (4) Install preformed packing (6) on idler shaft (7). CAUTION Ensure flat side of shaft is lined up to make proper contact. Failure to comply may result in damage to equipment. (5) Install idler shaft (7) in housing (2). NOTE Perform steps (5.1) and (5.2) on PTO Assembly (P/N 12378814-001). (5.1) Install preformed packing (7.1) on plug (9). (5.2) Position plug (9) in housing (2). NOTE Perform steps (6) and (7) on PTO Assembly (P/N 276XMF-JX-D5XK). (6) Install two preformed packings (8) on plug (9). (7) Position washer (10) and plug (9) in housing (2). (8) Tighten plug (9) to 97-106 lb-in. (11-16 N m). CAUTION Input gear should turn freely and have no side-to-side movement. Failure to comply may result in damage to equipment. (9) Turn input gear (4) in housing (2). 16-578.2 Change 1