TM-9-2320-366-34-3 MTV Direct Maintenance Manual M1083 Series - Volume 3 Download
Page 835 of 1178
TM 9-2320-366-34-3 Change 2 16-573 b. Disassembly. (1) Remove oil seal (1) from bearing cap (2). Discard oil seal. (2) Remove four screws (3) from bearing cap (2). (3) Remove bearing cap (2) and gasket (4) from housing (5). Discard gasket. (4) Remove solenoid electrical connector (6) from housing (5). (5) Remove retaining ring (7) from bearing cap (2). (6) Remove output shaft (8) from bearing cap (2). (7) Remove retaining ring (9) and bearing (10) from bearing cap (2). (8) Remove spacer (11) from output shaft (8). (9) Remove retaining ring (12) from output shaft (8). (10) Remove clutch back-up cylinder (13), vee ring (14), and piston (15) from output shaft (8). NOTE (11) Remove key (16) from output shaft (8). WARNING Use care when removing retaining rings. Retaining rings are under tension and can act as projectiles when released. Failure to comply may result in injury to personnel. Perform step (11) on PTO Assembly (P/N 276XMF-JX-D5XK).