TM-9-2320-366-34-3 MTV Direct Maintenance Manual M1083 Series - Volume 3 Download
Page 807 of 1178
TM 9-2320-366-34-3 (2) Dry metal parts with compressed air. (3) Inspect outer brake housing (1) for nicks or deep scratches. (4) Measure thickness of ten friction disc plates (2). Minimum thickness is 0.080 in. (0.203 cm). (5) Inspect ten friction disc plates (2) for wear marks, pitting, warping, and corrosion. (6) Measure thickness of nine brake drive plates (3). Minimum thickness is 0.055 in. (0.14 cm). (7) Inspect nine brake drive plates (3) for wear marks, pitting, warping, and corrosion. (8) Inspect gear teeth on brake shaft (4) wear, pitting, or broken teeth. (9) Inspect rotary seal surface on motor end support (5) for scratches and pits. (10) Check that spring loaded poppet on relief vent (6) operates freely. 16-547