TM-9-2320-366-34-3 MTV Direct Maintenance Manual M1083 Series - Volume 3 Download
Page 793 of 1178
TM 9-2320-366-34-3 16-86. PAY-OUT HYDRAULIC MOTOR REPLACEMENT This task covers: a. Removal b. Installation c. Follow-On Maintenance INITIAL SETUP Equipment Conditions Engine shut down (TM 9-2320-366-10-1). Tools and Special Tools Tool Kit, Genl Mech (Item 78, Appendix B) Wrench, Torque, 0-175 lb-ft (Item 92, Appendix B) Pan, Drain (Item 43, Appendix B) Tools and Special Tools (Cont) Wrench Set, Crowfoot, Ratcheting (TM 9-2320-366- 20) Materials/Parts Cap and Plug Set (Item 17, Appendix C) Sealing Compound (Item 75, Appendix C) Dispenser, Pressure Sensitive Adhesive Tape (Item 30, Appendix C) Preformed Packing (2) (Item 229, Appendix F) a. Removal. CAUTION Cap or plug hydraulic hoses to prevent contamination of hydraulic system. Failure to comply may result in damage to equipment. NOTE • Left and right side pay-out hydraulic motors are removed the same way. Left side shown. • Tag hydraulic hoses and connection points prior to disconnecting. (1) Position drain pan under pay-out hydraulic motor (1). (2) Disconnect two hoses (2) from fittings (3). (3) Remove two bolts (4), washers (5), and pay-out hydraulic motor (1) from spooler weldment (6). 16-535