TM-9-2320-366-34-3 MTV Direct Maintenance Manual M1083 Series - Volume 3 Download
Page 769 of 1178
TM 9-2320-366-34-3 (27) Install preformed packing (33) on plug (34). (28) Install pressure valve (35), spring (36), and plug (34) in valve (37). (29) Install gasket (38) in valve (23). (30) Install three gaskets (39) in valve (23). (31) Position valve (37) with valve (23). (32) Install gasket (40) in valve (37). (33) Install three gaskets (41) in valve (37). (34) Position valve (42) with valve (37). CAUTION Verify that valves are returned to their original configuration. Failure to comply may result in damage to equipment. NOTE • Apply lubricating oil to all studs prior to installation. • When positioning studs, washers and nuts, an even amount of threads must show on either side of stud after applying torque. (35) Position four studs (43), eight washers (44), and nuts (45) in lower control valve assembly (46). (36) Tighten eight nuts (45) to 29 lb-ft (39 N·m). (37) Re-tighten eight nuts (45) to 42 lb-ft (57 N·m). Change 1 16-516.9