TM-9-2320-366-34-3 MTV Direct Maintenance Manual M1083 Series - Volume 3 Download
Page 673 of 1178
TM 9-2320-366-34-3 16-75. M1089 RIGHT LOWER ARM ASSEMBLY REPLACEMENT/REPAIR This task covers: a. Removal b. Disassembly c. Cleaning/Inspection d. Assembly e. Installation f. Follow-On Maintenance INITIAL SETUP Equipment Conditions Underlift folding boom extended (TM 9-2320-366-10-2). Engine shut down (TM 9-2320-366-10-1). Tools and Special Tools Tool Kit, Genl Mech (Item 78, Appendix B) Wrench, Torque, 0-175 lb-ft (Item 92, Appendix B) Goggles, Industrial (Item 28, Appendix B) Wrench Set, Crowfoot Ratcheting (TM 9-2320-366-20) Press, Arbor Hand Operated (Item 48, Appendix B) Pliers, Retaining Ring (Item 46, Appendix B) Tools and Special Tools (Cont) Sling, Cargo (Item 56, Appendix B) Gloves, Rubber (Item 26, Appendix B) Materials/Parts Rag, Wiping (Item 60, Appendix C) Lockwasher (Item 130, Appendix F) Grease, Automotive and Artillery (Item 35, Appendix C) Personnel Required (2) a. Removal. (1) Remove screw (1), lockwasher (2), and washer (3) from pin (4). Discard lockwasher. NOTE Steps (2) through (4) require the aid of assistant. (2) Remove pin (4) from right lower arm (5). WARNING Use care when removing retaining rings. Retaining rings are under tension and can act as projectiles when released. Failure to comply may result in injury to personnel. (3) Remove retaining ring (6) from pin (7). (4) Remove right lower arm (5) from pin (7). 16-447