TM-9-2320-366-34-3 MTV Direct Maintenance Manual M1083 Series - Volume 3 Download
Page 651 of 1178
TM 9-2320-366-34-3 NOTE Left and right side of crossbar are assembled the same way. Left side shown. (9) Install pin (13) in crossbar (9). WARNING Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors, and are harmful to skin and clothing. Keep away from open fire and use in a well- ventilated area. If adhesive, solvent, or sealing compound gets on skin or clothing, wash immediately with soap and water. Failure to comply may result in injury to personnel. (10) Apply antiseize compound to adjusting screws (14). (11) Install adjusting screw (14) in mounting block (15). (12) Position mounting block (15) in crossbar (9). (13) Install pin (16) and latch pin (17) in mounting block (15). WARNING Adhesive Sealant MIL-S-46163 can damage your eyes. Wear safety goggles/glasses when using; avoid contact with eyes. If sealant contacts eyes, flush eyes with water and get immediate medical attention. Failure to comply may result in injury to personnel. (14) Apply sealing compound to threads of three screws (18 and 19). (15) Position adjustment block (20) and shim pack (21) in crossbar (9) with three washers (22) and screws (18). (16) Position three screws (19) in adjusting block (20). (17) Tighten three screws (18 and 19) to 76-84 lb-ft (103-114 N·m). (18) Install two nuts (23) on adjusting screw (14) with two spring pins (24). (19) Perform steps (9) through (18) on right side. 16-423