TM-9-2320-366-34-3 MTV Direct Maintenance Manual M1083 Series - Volume 3 Download
Page 628 of 1178
TM 9-2320-366-34-3 16-65. 30K WINCH RELIEF VALVE REPLACEMENT/REPAIR (CONT) c. Cleaning/Inspection. WARNING • Dry cleaning solvent (P-D-680) is TOXIC and flammable. Wear protective goggles and gloves; use only in well ventilated area; avoid contact with skin, eyes, and clothes, and do not breathe vapors. Keep away from heat or flame. Never smoke when using solvent; the flashpoint for Type I dry cleaning solvent is 100 ° F (38 ° C) and for Type II is 130 ° F (50 ° C). Failure to comply may result in serious injury or death to personnel. • If personnel become dizzy while using dry cleaning solvent, immediately get fresh air and medical help. If solvent contacts skin or clothes, flush with cold water. If solvent contacts eyes, immediately flush eyes with water and get immediate medical attention. Failure to comply may result in injury to personnel. (1) Clean all metal parts with dry cleaning solvent. (2) Replace any parts that fail visual inspection. d. Assembly. WARNING Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors, and are harmful to skin and clothing. Keep away from open fire and use in a well-ventilated area. If adhesive, solvent, or anti-seize compound gets on skin or clothing, wash immediately with soap and water. Failure to comply may result in injury to personnel. (1) Apply sealant to threads of plug (1). (2) Install plug (1) in valve (2). (3) Install preformed packing (3) on tee fitting (4). (4) Position tee fitting (4) in valve (2). (5) Install preformed packing (5) on two fittings (6). (6) Position two fittings (6) in valve (2). (7) Tighten tee fitting (4) and two fittings (6) to 40-43 lb-ft (54-58 N m). 16-390.2 Change 1