TM-9-2320-366-34-3 MTV Direct Maintenance Manual M1083 Series - Volume 3 Download
Page 598 of 1178
TM 9-2320-366-34-3 16-63. 30K WINCH ASSEMBLY REPLACEMENT/REPAIR (CONT) (20) Inspect input shaft (19) for pitted or broken spline teeth. (21) Inspect drive coupling (20) for pitted or broken spline teeth. (22) Measure compression spring (21) for minimum length of 3.00 in. (0.76 cm). (23) Inspect sun gear (22) for pitted or broken teeth. d. Assembly. WARNING Drum weighs approximately 350 lbs (159 kgs). Attach a suitable lifting device prior to assembly. Failure to comply may result in injury to personnel and/or damage to equipment. (1) Position drum (1) with cable clamp end down. NOTE Left and right side 30K winches are assembled the same way. Left side shown. (2) Install two keys (2) on output shaft (3). (3) Install output shaft (3) in drum (1). (4) Install thrust washer (4) in gear end support (5). (5) Install bearing (6) in gear end support (5). (6) Install seal (7) in gear end support (5). (7) Install gear end support (5) on drum (1). 16-362