TM-9-2320-366-34-3 MTV Direct Maintenance Manual M1083 Series - Volume 3 Download
Page 596 of 1178
TM 9-2320-366-34-3 16-63. 30K WINCH ASSEMBLY REPLACEMENT/REPAIR (CONT) c. Cleaning/Inspection. WARNING Dry Cleaning Solvent (P-D-680) is TOXIC and flammable. Wear protective goggles and gloves; use only in well ventilated area; avoid contact with skin, eyes, and clothes, and do not breathe vapors. Keep away from heat or flame. Never smoke when using solvent; the flashpoint for Type I Dry Cleaning Solvent is 100°F (38°C) and for Type II is 130°F (50°C). Failure to comply may result in serious injury or death to personnel. If personnel become dizzy while using cleaning solvent, immediately get fresh air and medical help. If dry cleaning solvent contacts skin or clothes, flush with cold water. If dry cleaning solvent contacts eyes, immediately flush eyes with water and get immediate medical attention. Failure to comply may result in injury to personnel. NOTE Replace any part that fails visual inspection or size measurement requirements. (1) Clean all parts with dry cleaning solvent. (2) Inspect brake housing (1) seating surface for nicks or scratches. (3) Inspect motor end support (2) seating surface for nicks or scratches. (4) Inspect brake shaft (3) inner spline and gear teeth for burrs, pitting, or broken teeth. (5) Inspect brake piston (4) for nicks, scratches or burrs. (6) Measure ten friction disc plates (5) for minimum thickness of 0.08 in. (0.2 cm). (7) Measure nine brake drive plates (6) for minimum thickness of 0.06 in. (0.14 cm). 16-360