TM-9-2320-366-34-3 MTV Direct Maintenance Manual M1083 Series - Volume 3 Download
Page 464 of 1178
TM 9-2320-366-34-3 16-41. M1089 CRANE TURNTABLE REPLACEMENT This task covers: a. Removal b. Installation c. Follow-On Maintenance INITIAL SETUP Equipment Conditions Mast removed (para 16-40). Tension link assembly removed (para 16-39). Erection cylinder removed (para 16-38). Tools and Special Tools Tool Kit, Genl Mech (Item 78, Appendix B) Wrench, Torque, 0-600 lb-ft (Item 97, Appendix B) Tools and Special Tools (Cont) Sling, Cargo (Item 56, Appendix B) Wrench Set, Socket (Item 84, Appendix B) Personnel Required (2) a. Removal. (1) Match mark turntable (1) to ring gear (2). (2) Remove 12 bolts (3) and washers (4) from turntable (1). (3) Remove four screws (5) and washers (6) from turntable (1). WARNING Turntable weighs approximately 130 lbs (59 kgs). Attach a suitable lifting device prior to removal. Failure to comply may result in injury to personnel or damage to equipment. NOTE Step (4) requires the aid of an assistant. (4) Remove turntable (1) from ring gear (2) and pass hydraulic hoses (7) and electrical cable (8) through center of turntable (1). 16-228