TM-9-2320-366-34-3 MTV Direct Maintenance Manual M1083 Series - Volume 3 Download
Page 457 of 1178
TM 9-2320-366-34-3 (5) Remove two screws (8), washers (9), and bushings (10) from rivet eyebolts (11). (6) Remove two rivet eyebolts (11) from pivot shaft (12). WARNING Tension link cylinder weighs approximately 60 lbs (27 kgs). Attach suitable lifting device prior to removal. Failure to comply may result in injury to personnel or damage to equipment. NOTE Drive out pivot shaft far enough to free tension link cylinder. (7) Drive pivot shaft (12) out of tension link cylinder (6). (8) Remove tension link cylinder (6) from turntable (13). (9) Remove four grease fittings (14) from tension link cylinder (6). (10) Perform steps (1) through (9) on left side tension link cylinder (6). b. Installation. NOTE Left and right side tension link cylinders are installed the same way. Right side shown. (1) Install four grease fittings (1) in tension link cylinder (2). 16-221