TM-9-2320-366-34-3 MTV Direct Maintenance Manual M1083 Series - Volume 3 Download
Page 365 of 1178
TM 9-2320-366-34-3 16-26. M1084/M1086 OUTRIGGER JACK CYLINDER REPLACEMENT This task covers: a. Removal b. Installation INITIAL SETUP Equipment Conditions Jack cylinder lowered approximately 12 inches (TM 9-2320-366-10-1). Engine shut down (TM 9-2320-366-10-1). Tools and Special Tools Tool Kit, Genl Mech (Item 78, Appendix B) Jack, Dolly Type, Hydraulic (Item 37, Appendix B) Pan, Drain (Item 43, Appendix B) Materials/Parts Cap and Plug Set (Item 17, Appendix C) Lockwasher (4) (Item 138, Appendix F) Pin, Cotter (2) (Item 326, Appendix F) Packing, Preformed (2) (Item 236, Appendix F) Packing, Preformed (2) (Item 235, Appendix F) Personnel Required (2) a. Removal. NOTE Left and right outrigger jack cylinders are removed the same way. Right side shown. (1) Disconnect connector (1) from cable (2). (2) Remove four screws (3), lockwashers (4), and cover plate (5) from outrigger (6). Discard lockwashers. (3) Position floor jack under jack cylinder (7). (4) Place drain pan under hoses (8). 16-129