TM-9-2320-366-34-3 MTV Direct Maintenance Manual M1083 Series - Volume 3 Download
Page 358 of 1178
TM 9-2320-366-34-3 16-23. M1084/M1086 SWING DRIVE ASSEMBLY REPLACEMENT/REPAIR (CONT) e. Installation. (1) Install oil fill pipe (1) in swing drive assembly (2). (2) Fill swing drive assembly (2) with oil. (3) Remove two screws (3) and plate (4) from swing drive assembly (2). (4) Install swing drive lifting bracket on swing drive assembly (2) with two screws (3). WARNING • Swing drive assembly weighs approximately 70 lbs (32 kgs). Attach a suitable lifting device prior to installation. Failure to comply may result in injury to personnel or damage to equipment. • Wear appropriate eye protection when working under vehicle due to the possibility of falling debris. Failure to comply may result in injury to personnel. NOTE Swing drive gear must be meshed with rotation gear during installation of swing drive assembly. (5) Lift swing drive assembly (2) in mounting position. (6) Position swing drive assembly (2) in crane assembly (5) with nine washers (6) and screws (7). (7) Tighten screws (7) to 90-110 lb-ft (122-149 N m). 16-122