TM-9-2320-366-34-3 MTV Direct Maintenance Manual M1083 Series - Volume 3 Download
Page 258 of 1178
TM 9-2320-366-34-3 16-4. M1084/M1086 BOOM FLY SECTION REPLACEMENT/ADJUSTMENT (CONT) b. Cleaning/Inspection. WARNING • Dry Cleaning Solvent (P-D-680) is TOXIC and flammable. Wear protective goggles and gloves; use only in well ventilated area; avoid contact with skin, eyes, and clothes, and do not breathe vapors. Keep away from heat or flame. Never smoke when using solvent; the flashpoint for Type I dry cleaning solvent is 100°F (38°C) and for Type II is 130°F (50°C). Failure to comply may result in serious injury or death to personnel. • If personnel become dizzy while using cleaning solvent, immediately get fresh air and medical help. If solvent contacts skin or clothes, flush with cold water. If solvent contacts eyes, immediately flush eyes with water and get immediate medical attention. Failure to comply may result in serious injury or death to personnel. (1) Clean two upper wear pads (1) thoroughly with dry cleaning solvent. (2) Measure thickness of two upper wear pads (1). Replace wear pad if thickness measures less than 0.25 in. (0.635 cm). (3) Clean two body wear pads (2) thoroughly with dry cleaning solvent. (4) Measure thickness of two body wear pads (2). Replace wear pad if thickness measures less than 0.25 in. (0.635 cm). c. Installation. WARNING Adhesive sealant MIL-S-46163 can damage your eyes. Wear safety goggles/glasses when using; avoid contact with eyes. If sealant contacts eyes, flush eyes with water and get immediate medical attention. Failure to comply may result in injury to personnel. (1) Apply sealing compound to threads of two screws (1). (2) Install two upper wear pads (2) on boom fly section (3) with screws (1). (3) Apply grease to upper wear pads (2) and bottom edges of boom fly section (3). 16-22