TM-9-2320-366-34-3 MTV Direct Maintenance Manual M1083 Series - Volume 3 Download
Page 225 of 1178
TM 9-2320-366-34-3 15-11. M1090/M1094 DUMP BODY CAB PROTECTOR REPLACEMENT This task covers: a. Removal b. Installation c. Follow-On Maintenance INITIAL SETUP Equipment Conditions Engine shut down (TM 9-2320-366-10-1). Cab protector raised (TM 9-2320-366-10-1). Tools and Special Tools Tool Kit, Genl Mech (Item 78, Appendix B) Hammer, Hand (Item 31, Appendix B) Pivot Pin Removal Tool, Dump Body Cab Protector (Item 7, Appendix D) Tools and Special Tools (Cont) Sling, Cargo (Item 56, Appendix B) Material/Parts Rope, Fibrous (2) (25 ft long) (Item 62, Appendix C) Personnel Required (3) a. Removal. (1) Tie guide ropes to each side of cab protector (1). (2) Remove two spring pins (2) from pivot shaft (3). WARNING Cab protector weighs approximately 185 lbs (84 kgs). Attach a suitable lifting device prior to removal. Failure to comply may result in injury to personnel or damage to equipment. (3) Remove pivot shaft (3) from right side of cab protector (1). NOTE Step (4) requires the aid of two assistants. (4) Remove cab protector (1) from dump body (4). (5) Remove three torsion springs (5) from dump body (4). 15-145