TM-9-2320-366-34-3 MTV Direct Maintenance Manual M1083 Series - Volume 3 Download
Page 197 of 1178
TM 9-2320-366-34-3 Change 2 15-123 15-8. M1090 REAR FENDER MOUNTING BRACKET AND EXTENSION BRACKET REPLACEMENT This task covers: a. Removal b. Installation c. Follow-On Maintenance INITIAL SETUP Equipment Conditions Dump body raised to maintenance position (TM 9- 2320-366-10-1). Rear fender removed (TM 9-2320-366-20-4). Tools and Special Tools Tool Kit, Genl Mech (Item 78, Appendix B) Goggles, Industrial (Item 28, Appendix B) Wrench, Torque, 0-600 lb-ft (Item 97, Appendix B) Tools and Special Tools (Cont) Wrench Set, Socket (Item 84, Appendix B) Materials/Parts Bolt (2) (Item 7, Appendix F) Bolt (3) (Item 8, Appendix F) Nut, Self-Locking (5) (Item 205, Appendix F) Personnel Required (2) a. Removal. (1) Remove two self-locking nuts (1), bolts (2), and extension bracket (3) from rear fender mounting bracket (4). Discard self-locking nuts. WARNING Wear appropriate eye protection when working under vehicle due to the possibility of falling debris. Failure to comply may result in injury to personnel. NOTE • Left and right side rear fender mounting brackets and extension brackets are removed the same way. Left side shown. • Steps (1) and (5) require the aid of an assistant.