TM-9-2320-366-34-3 MTV Direct Maintenance Manual M1083 Series - Volume 3 Download

Page 192 of 1178

TM 9-2320-366-34-3 15-7. CAB WINDSHIELD, SIDE WINDOW AND DOOR SIDE WINDOW REPLACEMENT (CONT) CAUTION While twine is being removed from inside of cab, always tap behind the twine (with soft head hammer) on outside of cab to seat seal. Always start from RH lower part of windshield and work to the LH side of vehicle. DO NOT start tapping at the middle of the windshield. Failure to comply may result in damage to equipment. (6) Remove RH side of twine until twine is 12 in. (305 mm) up RH side on windshield (1) as shown. (7) Remove LH side of twine until twine is 12 in. (305 mm) up LH side of windshield (1) as shown. CAUTION After using windshield setting tool, tap bottom section of seal lightly with soft head hammer to ensure proper fit with cab. Use caution not to hit glass. Failure to comply may result in damage to equipment. (8) Insert bottom of seal (2) evenly with cab (3) using windshield setting tool and soft head hammer. (9) Pull down on LH and RH top corners (4 and 5) of windshield (1). 15-120.4 Change 1