TM-9-2320-366-34-3 MTV Direct Maintenance Manual M1083 Series - Volume 3 Download
Page 147 of 1178
TM 9-2320-366-34-3 (28) Connect three pneumatic hoses (37) to 45-degree fittings (38). WARNING Adhesive Sealant MIL-S-46163 can damage your eyes. Wear safety goggles when using; avoid contact with eyes. Failure to comply may result in injury to personnel. If sealant contacts eyes, flush eyes with water and get immediate medical attention. Failure to comply may result in injury to personnel. (29) Apply sealing compound to threads of two screws (39). (30) Position two screws (39) in left side bearing housing (25). (31) Tighten two screws (39) to 34-42 lb-ft (47-57 N·m). (32) Perform steps (29) through (31) on right side bearing housing. (33) Position steering column universal joint (40) on steering gear (41) with matchmarks aligned. (34) Position screw (42) and self-locking nut (43) in steering column universal joint (40). (35) Tighten self-locking nut (43) to 31-39 lb-ft (43-53 N·m). NOTE Install plastic cable ties as required. (36) Route throttle control cable (44) to bracket (45). (37) Position throttle control cable (44) in bracket (45) with two nuts (46). (38) Adjust and tighten nuts (46) to position marked during removal. (39) Install throttle control cable (44) on stud (47) with clip (48). 15-81