TM-9-2320-366-34-3 MTV Direct Maintenance Manual M1083 Series - Volume 3 Download
Page 130 of 1178
TM 9-2320-366-34-3 15-3. CAB FRONT SUPPORT REPLACEMENT/REPAIR (CONT) (53) Match mark universal joint (90) to steering gear (91). (54) Remove self-locking nut (92) and screw (93) from universal joint (90). Discard self-locking nut. (55) Remove two screws (94) from left side bearing housing (95). (56) Perform step (55) on right side bearing housing. (57) Disconnect three pneumatic hoses (96) from 45-degree fittings (97). WARNING Cab must be braced on cab support tool prior to removal of cotter pin from cab tilt cylinder mounting bolt. Failure to comply may result in injury to personnel or damage to equipment. (58) Install cab support tool on engine rear lifting eye (98). (59) Lower cab until cab rests on cab support tool (TM 9- 2320-366-10-1). 15-68