TM-9-2320-366-34-3 MTV Direct Maintenance Manual M1083 Series - Volume 3 Download
Page 105 of 1178
TM 9-2320-366-34-3 NOTE Perform steps (10) through (16) if rear weld nuts are damaged. (10) Measure and mark a line (7) half way, 0.625 in. (15.6 mm), between two forward weld nuts (8). (11) Measure and mark a line (9), 4.500 in. (112.5 mm), in back from front weld nuts (8) on line (10). (12) Drill a pilot hole at intersection of lines (9 and 10). (13) Drill a 2 in. (49 mm) hole at pilot hole. (14) Remove damaged weld nut (11) as required. NOTE Steps (15) and (16) require the aid of an assistant. (15) Position screw (12) and self-locking nut (13) in cab support (3). (16) Tighten screw (12) to 42-52 lb-ft (57-71 N·m). (17) Install spring washer (14) and control cam (15) in cab tilt cylinder (16) with matchmarks aligned. Change 1 15-47