TM-9-2320-366-34-2 MTV Direct Maintenance Manual M1083 Series - Volume 2 Download
Page 829 of 1434
TM 9-2320-366-34-2 Change 2 13-171 13-22. M1088 FRAME PLATE REPLACEMENT (WITHOUT FRAME RAIL KIT) This task covers: a. LH Removal b. LH Installation c. RH Removal d. RH Installation e. Follow-On Maintenance INITIAL SETUP Equipment Conditions Fifth wheel assembly removed (para 13-46). Rear axle bogie shaft removed (para 10-4). Rear torque rods removed (para 14-5). Resilient mount and mechanical stops removed (TM 9-2320-366-20-4). Tools and Special Tools Tool Kit, Genl Mech (Item 78, Appendix B) Goggles, Industrial (Item 28, Appendix B) Wrench, Torque, 0-600 lb-ft (Item 97, Appendix B) Wrench Set, Socket (Item 84, Appendix B) Wrench, Impact, Electric (Item 88, Appendix B) Socket Set, Impact (Item 58, Appendix B) Wrench, Torque 0-150 lb-in. (Item 91, Appendix B) Wrench Set, Socket (Item 85, Appendix B) Materials/Parts Nut, Self-Locking (3) (Item 173, Appendix F) (LH side) Nut, Self-Locking (2) (Item 173, Appendix F) (RH side) Lockwasher (Item 166, Appendix F) Nut, Self-Locking (Item 202, Appendix F) Nut, Self-Locking (8) (Item 212, Appendix F) Bolt (13) (Item 2, Appendix F) Nut, Self-Locking (13) (Item 204, Appendix F) Nut, Self-Locking (2) (Item 210, Appendix F) Nut, Self-Locking (4) (Item 211, Appendix F) Adhesive (Item 10.1, Appendix C) Grommet, Nonmetallic (Item 71.1, Appendix F) Personnel Required (2) a. LH Removal. (1) Remove two self-locking nuts (1), bolts (2), and clamps (3) from frame plate (4). Discard self- locking nuts. WARNING Wear appropriate eye protection when working under vehicle due to the possibility of falling debris. Failure to comply may result in injury to personnel.