TM-9-2320-366-34-2 MTV Direct Maintenance Manual M1083 Series - Volume 2 Download
Page 777 of 1434
TM 9-2320-366-34-2 13-17. M1094 FRAME PLATE REPLACEMENT This task covers: a. LH Removal b. LH Installation c. RH Removal d. RH Installation e. Follow-On Maintenance INITIAL SETUP Equipment Conditions M1090/M1094 dump body removed (para 15-10). Rear axle bogie shaft removed (para 10-4). Rear torque rods removed (para 14-5). Resilient mount and mechanical stops removed (TM 9- 2320-366-20-4). 15K Self-Recovery winch (SRW) cable pulleys removed, if equipped (RH side) (TM 9-2320-366-20-5). M1094 suspension bracket removed (para 13-13). Tools and Special Tools Tool Kit, Genl Mech (Item 78, Appendix B) Wrench, Torque, 0-600 lb-ft (Item 97, Appendix B) Wrench Set, Socket (Item 84, Appendix B) Goggles, Industrial (Item 28, Appendix B) Wrench, Torque, 0-150 lb-in. (Item 91, Appendix B) Wrench, Torque, 0-175 lb-ft (Item 92, Appendix B) Socket Set, Socket Wrench (Item 59, Appendix B) Wrench, Impact, Electric (Item 88, Appendix B) Socket Set, Impact (Item 58, Appendix B) Multiplier, Torque Wrench (Item 42, Appendix B) Wrench Set, Socket (Item 85, Appendix B) Materials/Parts Nut, Self-locking (Item 173, Appendix F) (RH side) Nut, Self-locking (3) (Item 173, Appendix F) (LH side) Nut, Self-locking (Item 202, Appendix F) Lockwasher (Item 165, Appendix F) Nut, Self-locking (8) (Item 212, Appendix F) Bolt (20) (Item 2, Appendix F) (LH side and RH side without winch) Nut, Self-locking (20) (Item 204, Appendix F) (LH side and RH side without winch) Bolt (17) (Item 2, Appendix F) (RH side with winch) Nut, Self-locking (17) (Item 204, Appendix F) (RH side with winch) Bolt (8) (Item 7, Appendix F) Nut, Self-locking (8) (Item 211, Appendix F) Sealing Compound (Item 67, Appendix C) Personnel Required (2) WARNING Wear appropriate eye protection when working under vehicle due to the possibility of falling debris. Failure to comply may result in injury to personnel. a. LH Removal (1) Remove two self-locking nuts (1), bolts (2), and clamps (3), from frame plate (4). Discard self-locking nuts. 13-119