TM-9-2320-366-34-2 MTV Direct Maintenance Manual M1083 Series - Volume 2 Download
Page 752 of 1434
TM 9-2320-366-34-2 13-15. M1093 FRAME PLATE REPLACEMENT This task covers: a. LH Removal b. LH Installation c. RH Removal d. RH Installation e. Follow-On Maintenance INITIAL SETUP Equipment Conditions Rear axle bogie shaft removed (para 10-4). Rear torque rods removed (para 14-5). Resilient mount and mechanical stops removed (TM 9- 2320-366-20-4). M1093 parachute suspension assembly removed (para 13-4). 15K Self-Recovery winch (SRW) cable pulleys removed, if equipped (RH side) (TM 9-2320-366-20-5). Rear axle rear shock absorber brackets removed (para 14-9). Stabilizer mounting bracket removed (para 14-10). Taillight carriers removed (TM 2320-366-20-4). Tools and Special Tools Tool Kit, Genl Mech (Item 78, Appendix B) Goggles, Industrial (Item 28, Appendix B) Wrench, Torque, 0-600 lb-ft (Item 97, Appendix B) Wrench Set, Socket (Item 84, Appendix B) Wrench, Torque, 0-150 lb-in. (Item 91, Appendix B) Wrench, Torque, 0-175 lb-ft (Item 92, Appendix B) Socket Set, Socket Wrench (Item 59, Appendix B) Wrench, Impact, Electric (Item 88, Appendix B) Tools and Special Tools Wrench Set, Socket (Item 85, Appendix B) Socket Set, Impact (Item 58, Appendix B) Materials/Parts Nut, Self-locking (Item 173, Appendix F) (RH side) Nut, Self-locking (Item 202, Appendix F) Lockwasher (Item 182, Appendix F) Nut, Self-locking (3) (Item 173, Appendix F) (LH side) Nut, Self-locking (8) (Item 212, Appendix F) Bolt (2) (Item 3, Appendix F) Bolt (18) (Item 2, Appendix F) (LH side and RH side without winch) Nut, Self-locking (20) (Item 204, Appendix F) (LH side and RH side without winch) Bolt (15) (Item 2, Appendix F) (RH side with winch) Nut, Self-locking (17) (Item 204, Appendix F) (RH side with winch) Personnel Required (2) WARNING Wear appropriate eye protection when working under vehicle due to the possibility of falling debris. Failure to comply may result in injury to personnel. a. LH Removal. (1) Remove two self-locking nuts (1), bolts (2), and clamps (3) from frame plate (4). Discard self-locking nuts. 13-94