TM-9-2320-366-34-2 MTV Direct Maintenance Manual M1083 Series - Volume 2 Download
Page 736 of 1434
TM 9-2320-366-34-2 13-12. M1094 EXTRACTION TUBE AND EXTENSION BRACKET REPLACEMENT This task covers: a. Removal b. Installation c. Follow-On Maintenance INITIAL SETUP Equipment Conditions Dump body raised (TM 9-2320-366-10-1). Rear fender removed (TM 9-2320-366-20-4). Tools and Special Tools Tool Kit, Genl Mech (Item 78, Appendix B) Goggles, Industrial (Item 28, Appendix B) Wrench, Torque, 0-175 lb-ft (Item 92, Appendix B) Wrench Set, Socket (Item 84, Appendix B) Wrench, Impact, Electric (Item 88, Appendix B) Socket Set, Impact (Item 58, Appendix B) Multiplier, Torque Wrench (Item 42, Appendix B) Tools and Special Tools (Cont) Vise, Machinist (Item 82, Appendix B) Materials/Parts Lockwasher (16) (Item 142, Appendix F) Lockwasher (2) (Item 140, Appendix F) Nut, Self-locking (5), (Item 211, Appendix F) Bolt (2), (Item 10, Appendix F) Personnel Required (2) WARNING Wear appropriate eye protection when working under vehicle due to the possibility of falling debris. Failure to comply may result in injury to personnel. a. Removal. NOTE • Left and right side extraction tubes are removed the same way. Left side shown. • Steps (1) through (4) require the aid of an assistant. (1) Remove two self-locking nuts (1), bolts (2), and extension bracket (3) from extraction tube (4). Discard self-locking nuts. 13-78