TM-9-2320-366-34-2 MTV Direct Maintenance Manual M1083 Series - Volume 2 Download
Page 706 of 1434
TM 9-2320-366-34-2 13-7. REAR CROSSMEMBER REPLACEMENT (CONT) (3) Position two bolts (4) and self-locking nuts (5) in rear crossmember (1). (4) Tighten two self-locking nuts (5) to 210-225 lb-ft (285- 305 N·m). (5) Perform steps (1) through (4) on right side of rear crossmember. (6) Position support (6) on rear crossmember (1) with four screws (7) and self-locking nuts (8). (7) Tighten four self-locking nuts (8) to 195-239 lb-ft (265- 325 N·m). (8) Install pintle hook (9) in rear crossmember (1) with washer (10) and nut (11). CAUTION Clearance between washer and support must be 0.003-0.017 in. (0.007-0.043 cm). Failure to comply may result in damage to equipment. (9) Adjust nut (11) until clearance is 0.003-0.017 in. (0.007- 0.043 cm) with alignment holes lined up between nut and pintle hook (9). (10) Install cotter pin (12) in nut (11). k. Follow-on Maintenance (1) Lubricate pintle hook (TM 9-2320-366-20). (2) Install M1094 extraction tube (para 13-12). (3) Install M1083/M1093 rear shock absorbers (TM 9-2320- 366-20-4). 13-48