TM-9-2320-366-34-2 MTV Direct Maintenance Manual M1083 Series - Volume 2 Download
Page 700 of 1434
TM 9-2320-366-34-2 13-7. REAR CROSSMEMBER REPLACEMENT (CONT) (11) Position bolt (13) and self-locking nut (14) in front shock absorber bracket (15). (12) Position bolt (16) and self-locking nut (17) in rear shock absorber bracket (18). (13) Tighten self-locking nuts (14 and 17) to 210-225 lb-ft (285-305 N·m). (14) Perform steps (2) through (13) on right side of rear crossmember. (15) Position support (19) on rear crossmember (1) with four screws (20) and self-locking nuts (21). (16) Tighten four self-locking nuts (21) to 195-239 lb-ft (265- 325 N·m). (16.1) Apply coat of grease to shaft of pintle hook (22). (17) Install pintle hook (22) in rear crossmember (1) with washer (23) and nut (24). CAUTION Clearance between washer and support must be 0.003-0.017 in. (0.007-0.043 cm). Failure to comply may result in damage to equipment. (18) Adjust nut (24) until clearance is 0.003-0.017 in. (0.007- 0.043 cm) with alignment holes lined up between nut (24) and pintle hook (22). (19) Install cotter pin (25) in nut (24). 13-42 Change 1