TM-9-2320-366-34-2 MTV Direct Maintenance Manual M1083 Series - Volume 2 Download
Page 693 of 1434
TM 9-2320-366-34-2 (6) Position support (6) on rear crossmember (1) with four screws (7) and self-locking nuts (8). (7) Tighten four self-locking nuts (8) to 195-239 lb-ft (265- 325 N·m). (7.1) Apply coat of grease to shaft of pintle hook (9). (8) Install pintle hook (9) in rear crossmember (1) with washer (10) and nut (11). CAUTION Clearance between washer and support must be 0.003-0.017 in. (0.007-0.043 cm). Failure to comply may result in damage to equipment. (9) Adjust nut (11) until clearance is 0.003-0.017 in. (0.007- 0.043 cm) with alignment holes lined up between nut and pintle hook (9). (10) Install cotter pin (12) in nut (11). c. M1088 Removal. (1) Remove cotter pin (1) from nut (2). Discard cotter pin. (2) Remove nut (2) and washer (3) from pintle hook (4). (3) Remove pintle hook (4) from rear crossmember (5). (4) Remove four self-locking nuts (6), screws (7), and support (8) from rear crossmember (5). Discard self- locking nuts. Change 1 13-35