TM-9-2320-366-34-2 MTV Direct Maintenance Manual M1083 Series - Volume 2 Download

Page 654 of 1434

TM 9-2320-366-34-2 12-12 Change 2 12-3. STEERING GEAR ASSEMBLY ADJUSTMENT (CONT) (24) Perform drag link adjustment (TM 9-2320-366-20-3). (25) Start engine (TM 9-2320-366-10-1). (26) Turn steering wheel to left until stops are reached and hold for ten seconds. Check pressure reading on STE/ICE-R. Pressure reading should be between 500-1000 psi (3448-6895 kPa). (27) Turn wheels straight ahead. (28) Loosen locknut (17) on top adjustment screw (18). (29) Adjust top adjustment screw (18) to right or left. (30) Turn steering wheel to left until stops are reached and verify pressure is 650-750 psi (4482-5171 Kpa). (31) Turn wheels straight ahead. (32) Tighten locknut (17) on top adjustment screw (18) to 22 lb-ft (30 N•m). CAUTION NOTE Step (24) is required if wheels do not point straight ahead. NOTE If initial pressure is less than 5 psi replace power steering pump (para 12-4). NOTE If pressure reading is not within range, turn adjustment screw right to decrease pressure or left to increase pressure. Ensure adjustment screw does not turn when tightening locknut. Failure to comply may result in damage to equipment. NOTE Repeat steps (29) through (31) until pressure reading of 650-750 psi (4482-5171 Kpa) is obtained.