TM-9-2320-366-34-2 MTV Direct Maintenance Manual M1083 Series - Volume 2 Download

Page 648 of 1434

TM 9-2320-366-34-2 12-2. STEERING GEAR REPLACEMENT (CONT) (7) Place bracket (6) on steering gear assembly (1). NOTE Bolts installed in steps (8) and (9) are different lengths. Position bolts in tagged locations. (8) Position three bolts (7) in bracket (6). (9) Position bolt (8) in bracket (6). (10) Tighten three bolts (7) and bolt (8) to 372-454 lb-ft (504- 616 N m). WARNING Steering gear assembly weighs approximately 130 lbs (59 kgs). Support steering gear assembly on jack during installation. Failure to comply may cause injury to personnel or damage to equipment. NOTE Steps (11) through (15) require the aid of an assistant. (11) Remove steering gear assembly (1) from vise and place on jack. (12) Raise steering gear assembly (1) to mounting location. NOTE Bolts in steps (13) and (14) are different lengths. Install bolts in holes marked during removal. (13) Position five bolts (9) and self-locking nuts (10) in bracket (6). (14) Position bolt (11) and self-locking nut (12) in bracket (6). (15) Tighten five self-locking nuts (10) and self-locking nut (12) to 232-284 lb-ft (315-385 N m) in sequence shown. 12-6