TM-9-2320-366-34-2 MTV Direct Maintenance Manual M1083 Series - Volume 2 Download
Page 644 of 1434
TM 9-2320-366-34-2 Section II. MAINTENANCE PROCEDURES 12-2. STEERING GEAR REPLACEMENT This task covers: a. Removal b. Installation c. Follow-On Maintenance INITIAL SETUP Equipment Conditions Engine shut down (TM 9-2320-366-10-1). Cab raised (TM 9-2320-366-10-1). Radiator removed (TM 9-2320-366-20-3) Tools and Special Tools Tool Kit, Genl Mech (Item 78, Appendix B) Wrench, Torque, 0-175 lb-ft (Item 92, Appendix B) Wrench, Torque, 0-600 lb-ft (Item 97, Appendix B) Wrench Set, Socket (Item 84, Appendix B) Vise, Machinists (Item 82, Appendix B) Pan, Drain (Item 43, Appendix B) Adapter, Socket Wrench (Item 2, Appendix B) Puller, Mechanical (Item 53, Appendix B) Tools and Special Tools (Cont) Jack, Dolly Type, Hydraulic (Item 37, Appendix B) Materials/Parts Cap and Plug Set (Item 17, Appendix C) Nut, Plain, Hex (Item 171, Appendix F) Nut, Self-Locking (6) (Item 211, Appendix F) Pin, Cotter (Item 328, Appendix F) Dispenser, Pressure Sensitive Adhesive Tape (Item 30, Appendix C) Personnel Required (2) WARNING Ensure engine is cool before performing maintenance. Failure to comply may result in injury to personnel. a. Removal. CAUTION • Ensure steering axle wheels are pointed straight ahead. Failure to comply may result in damage to equipment. • Cap or plug hydraulic hoses and fittings to prevent contamination of hydraulic system. Failure to comply may result in damage to equipment. (1) Place drain pan under vehicle. (2) Remove plug (1) and two metal ring seals (2) from power steering return hose (3). 12-2