TM-9-2320-366-34-2 MTV Direct Maintenance Manual M1083 Series - Volume 2 Download
Page 631 of 1434
TM 9-2320-366-34-2 Change 2 10-61 (8.1) Tighten four screws (11) to 26-35 lb-ft (35-47 N•m). (9) Position universal joint (8) on drive yoke (9) with two bearing cups (10) and four screws (11). (10) Tighten four screws (11). (10.1)Tighten four screws (11) to 26-35 lb-ft (35-47 N•m). (10.2) Fold tabs on four screws (11). (11) Apply lubrication to grease fittings (TM 9-2320-366-20). CAUTION NOTE • Perform step (10) on kits equipped with shearhead screws. • Alternately tighten screws. • When correct torque is reached, bearing cap screw small hex head will break off. NOTE • There are two type of bearing cups, those with tabs and those without. Perform step (8.1) on bearing cups not equipped with tabs. • Perform step (8.1) on kits equipped with screws P/N C5 H5-24-39. NOTE Perform steps (10.1) and (10.2) on bearing cups equipped with tabs. Grease must flow from all four seals. Failure to comply may result in damage to equipment.