TM-9-2320-366-34-2 MTV Direct Maintenance Manual M1083 Series - Volume 2 Download
Page 627 of 1434
TM 9-2320-366-34-2 Change 2 10-59 10-9. REAR AXLE DIFFERENTIAL CARRIER REPLACEMENT This task covers: a. Removal b. Installation c. Follow-On Maintenance INITIAL SETUP Equipment Conditions Rear axle shaft removed (TM 9-2320-366-20-4). Rear axle differential carrier drained (TM 9-2320- 366-20). Tools and Special Tools Tool Kit, Genl Mech (Item 78, Appendix B) Goggles, Industrial (Item 28, Appendix B) Wrench, Torque, 0-175 lb-ft (Item 92, Appendix B) Lift, Transmission/Differential (Item 39, Appendix B) Wrench Set, Socket (TM 9-2320-366-20) Pan, Drain (Item 43, Appendix B) Tools and Special Tools (Cont) Sling, Cargo (Item 56, Appendix B) Hammer, Hand, Soft Head (Item 33, Appendix B) Materials/Parts Sealant, Adhesive (Item 51, Appendix C) Screw, Cap (4) (Item 366.1, Appendix F) Personnel Required (2) a. Removal. (1) Lift tabs from two bearing cups (1). (1.1) Remove four screws (2) and two bearing cups (1) from drive yoke (3). Discard screws. (2) Slide drive shaft (4) from side to side and separate universal joint (5) from drive yoke (3). NOTE (3) Attach drive shaft (4) to frame (6). WARNING Wear appropriate eye protection when working under vehicle due to the possibility of falling debris. Failure to comply may result in injury to personnel. Step (3) requires the aid of an assistant. NOTE There are two types of bearing cups, those with tabs and those without. Perform step (1) on bearing cups with tabs.