TM-9-2320-366-34-2 MTV Direct Maintenance Manual M1083 Series - Volume 2 Download
Page 626 of 1434
TM 9-2320-366-34-2 10-58 Change 2 10-8. REAR AXLE DIFFERENTIAL PINION SEAL, YOKE SEAL AND DRIVE YOKE REPLACEMENT (CONT) (9.1) Tighten four screws (11) to 26-35 lb-ft (35-47 N•m). (9.2) Fold tabs on four screws (11). (10) Apply lubrication to grease fittings (TM 9-2320-366- 20). c. Follow-On Maintenance. (1) Check differential oil level (TM 9-2320-366-20). (1.1) Lubricate drive shaft universal joint and slip yoke (TM 9-2320-366-20-1). (2) Operate vehicle and check for proper operation (TM 9-2320-366-10-1). (3) Shut down engine (TM 9-2320-366-10-1). (4) Check pinion seal for oil leaks. End of Task. CAUTION Grease must flow from all four seals. Failure to comply may result in damage to equipment. NOTE Perform the following two steps on bearing cups equipped with tabs.